This document has been published to be used for
after sales service only.
The contents are subject to change without notice.
CHAPTER 1. SPECIFICATION
CHAPTER 2. DESIGNATION OF VARIOUS PARTS
[1] EXTERNAL DESCRIPTION........................... 2-1
2-2...............................SNOITCURTSNOC ]2[ .........
CHAPTER 3. DIMENTIONS
[1] OUTER DIMENTIONS AND
3-1........................................ECNARAELC .........
[2] INNER DIMENTIONS .................................... 3-2
CHAPTER 4. LIST OF ELECTORICAL PARTS
CHAPTER 5. WIRING DIAGRAM
[1] WIRING DIAGRAM ........................................ 5-1
[2] ELECTRIC ACCESSORIES LAYOUT ........... 5-2
CHAPTER 6. FAILURE DIAGNOSIS
[1] OUTLINE OF CONTROL ............................... 6-1
[2] CHECK MODE OF DEFROST HEATER
(Forced Defrosting) ........................................ 6-1
[3] RE-SETTING OF MICROCOMPUTER AT
POWER FAILURE.......................................... 6-1
[4] DIAGNOSIS METHOD OF FAILURE ............6-2
[5] CONVERSION TABLE ..................................6-3
[6] CIRCUIT DIAGRAM OF MAIN PWB .............6-4
CHAPTER 7. FUNCTIONS
[1]
ADJUSTABLE TEMPERATURE
CONTROL .....................................................7-1
CHAPTER 8. ASSEMBLI NG PROCEDURES OF
MAIN PARTS AND CAUTIONS
[2] R CONTROL COV. ASS'Y.............................8-4
[3] HOW TO REPLACE THE LAMP ...................8-6
[4] DEFROST HEATER ..
....................................8-7
CHAPTER 9. COOLING UNIT
[1
] COOLING UNIT.............................................9-1
[2] LOCATION ....................................................9-2
Parts Guide
CONTENTS
To Next Page
Need help?
General
