EasyManua.ls Logo

Sharp SJ-F104VG - Installation

Sharp SJ-F104VG
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
ENGLISH
WARNING
Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
In order to prevent possible electric shock, install the
grounding wire to the earth wire connecting screw at
the rear of the refrigerator.
(2 pin plug region)
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned rmly and at on the oor.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
INSTALLATION
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
NOTE
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight.
Do not place next to heat generating appliance.
Do not place directly on the ground. Provide suitable stand.
To insert the power plug when the door is opened, door alarm
sounds but it is not abnormal. This sound stops when closing
the door.
Adjustable foot
When the left door is
raised.
When the right door is
raised.
Lower the foot
at right side.
Lower the foot
at left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
Screw
(4 screws)
Screw
Foot cover
Free standing type
1180 mm
1500 mm
Overall space
required in use
1
Keep adequate ventilation space around the refrigerator.
The gure shows the minimum
required space for installing
the refrigerator.
The measurement condition
of power consumption
is conducted under
a different space
dimension.
By keeping greater space,
the refrigerator may be
operated under a less amount
of power consumption.
If using the refrigerator in the smaller space dimension
than the below gure, it may cause the temperature
rise in the unit, loud noise and failure.
The space between the rear of the refrigerator and the
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts which
are extremely hot during the operation.
90mm
or more
60mm
or more
60mm
or more
(B593).indb3(B593).indb3 2014/05/2914:44:332014/05/2914:44:33

Related product manuals