SPC658
- When successfully paired and connected, the Pairing Indicator will display a solid blue light and a beep will sound
from the unit.
- Use the native controls on the connected Bluetooth device to select a track.
- To play or skip the selected track, use the native controls on the connected Bluetooth device.
- To pause the track, use the PLAY/PAUSE button on the alarm clock.
- Audio played through the connected Bluetooth device will now be heard through the speakers.
- To adjust the volume, press the VOL+/- button on the alarm clock.
After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of the device.
FCC WARNINGS
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
USING AUX IN FUNCTION
- Connect the 3.5mm audio cable (not included) to the AUX IN jack on the unit and an audio output on an MP3 player
or other audio source.
- Press the POWER ON button to enter AUX IN mode.
- Use the native controls on the connected MP3 player or other audio source to play and control audio played through
the alarm clock.
To Previous Page
Loading...
Need help?
General
