20
Connecting the Power Cord
Caution
• Do not use a power cord other than the one
supplied with the monitor.
Be sure to use a power outlet of
AC 100-240 V, 50/60 Hz.
Using power supply other than the
one specified may cause fire.
• Place the monitor close to the AC outlet, and
keep the power plug within reach.
• This product must only be connected to an AC
100-240 V, 50/60 Hz, grounded (3-prong) outlet.
Connecting it to any other kind of outlet will
damage the product and invalidate the warranty.
1
Plug the power cord (supplied) into the AC input
terminal.
2
Plug the power cord (supplied) into the AC power
outlet.
Binding Cables
n
Attaching the cable clamp
The cables connected to the terminals on the back
of the monitor can be neatly bundled using the
supplied cable clamp as shown in the illustration.
• A cable clamp cannot be easily removed once it is
attached.
n
Fastening the power cord
The power cord can be fastened using the supplied
power cord clamp. This will prevent the power cord
from being disconnected accidentally.
1
Attach the supplied power cord clamp to the
power cord, making sure the power cord clamp is
circular hole-side down.
2
Insert the tip of the band into the hole for the
power cord clamp.
3
While holding the tail of the band, slide the
fastened part toward the AC input terminal.
To Next Page
Loading...
