Using external equipment
AVC System (rear view)
ø 3.5 mm stereo minijack cable
(commercially available)
PC with analog RGB terminal
Connecting a PC
Use the INPUT 5 terminal to connect a PC.
ø 3.5 mm stereo minijack cable
(commercially available)
DVI cable
(Commercially available)
RGB/DVI conversion cable
(Commercially available)
PC with DVI terminal
Rear view
Connecting external speakers
When using external speakers
• Change the speaker setting to external speakers.
+
+
–
–
Make sure to connect the speaker terminal and
cable polarity ( , ) properly
• The speaker terminals have plus ( ) and minus ( )
polarity.
• Plus is red and minus is black.
• The cables are also divided into plus and minus.
• When connecting the left/right speakers, be sure to
connect the plus/minus terminals with the correct cables.
NOTE
• Unplug the AC cord from the AC outlet before installing
the speakers.
CAUTION
• Make sure external speakers have 4 ohm and 10 watt
specifications.
• Connect the plus/minus terminals with the correct cables.
Incorrect connection may cause a short.
How to connect the
speaker cable
Push down
the tab.
Insert the
end of the
cable.
Lift the tab
back up.
1
2
3
To Next Page
Loading...
