Sharp TU-GA1U-S - Preparation (Continued); Cable Management and Terminal Cover

13
TU-GA1U-S
TU-GAD
REMOVING OF MAJOR PARTS
1. Remove the two lock screws from each of the right and left side covers, and detach the side covers by sliding
them backward.
2. Remove the five lock screws from the top cabinet, and detach the cabinet by sliding it backward.
3. Remove the lock screws from the bottom cabinet, and detach the cabinet by sliding it backward.
4. Remove the tow lock screws from the front panel, and detach the panel.
5. Remove the lock screws, four tuner nuts and six hexagon shaft screws from the rear chassis, and detach the rear
chassis.
6. Remove the DVI PWB.
6-1. Remove the four lock screws from the DVI PWB angle.
6-2. Remove the four lock screws from the DVI PWB.
Top Cabinet
Side Cover (left)
Side Cover (right)
2
1
1
2
2
2
6-1
5
5
5
5
5
5
Rear Chassis
DVI PWB Angle
DVI PWB
6-2
Front Panel
Bottom Cabinet
3
3
4
3