Sharp TU-GA1U-S - Preparation (Continued); AVC System Stand Installation

14
TU-GA1U-S
TU-GAD
7. Remove the DC/DC converter PWB, TMDS PWB and AUDIO I/F PWB.
7-1. Remove the three lock screws from the TMDS PWB angle.
7-1. Remove the four lock screws from the DC/DC converter PWB.
7-3. Remove the four lock screws from the TMDS PWB.
7-4. Remove the two lock screws from the AUDIO I/F PWB.
8. Remove the five lock screws from the power PWB.
9. Remove the AV PWB, AV SUB PWB and 1-bit amplifier PWB.
9-1. Remove the four lock screws from the AV PWB angle.
9-2. Remove the one lock screw from the AV SUB PWB.
9-3. Remove the two lock screws from the 1-bit AMP PWB.
7-2
DC/DC Converter PWB
TMDS PWB
TMDS PWB Angle
7-3
7-1
7-1
7-4
TMDS PWB Shield
AUDIO I/F PWB
Power PWB
8
9-2
9-1
9-3
9-1
AV PWB
AV PWB Angle
AV SUB PWB
1-bit Amp PWB