Sharp VC-M303HM - Customised Installation; Manually Tuning a Channel

22
If problems persist contact the SHARP Helpline on tel: 0990-274277
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.
Press the MENU button.
2. Press the [ / ] menu select buttons
to select SET UP. Press the SET button
to confirm.
3.
CHANNEL PRESET will be
highlighted. Press the SET button.
4. Press [ / ] to select CHANNEL .
5. Press
[/]
to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press
[/] to continue tuning.
6.
Press [ / ] to select
FINE
TUNING
. Press and hold
[/]until
the sharpest colour picture is obtained.
7.
Press [ / ] to select SKIP.
The SKIP function determines whether the
channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS.
8. Press [/] to select ON or OFF for
this option.
9. Press SET to confirm.
10.
Press MENU to leave this function.
CHANNEL PRESET
CHANNEL SORT
CLOCK
➔
PRESET 1
CHANNE L CH2 1
FINE TUNING
▲
▲
SKIP ON OF F
:
SET
SET
CHANNEL
CHANNEL
MENU SET
CLEAR
DISPLAY
SV/V+/
TIMER
MODE OSD
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
ZERO
BACK
231
SET
Remote Control