15
If problems persist contact the SHARP Helpline on tel: 0990-274277
BASIC OPERATION
HOW TO SET A DELAYED RECORDING
You can make a maximum of eight delayed recordings up to a year in advance.
The example shown is for 24-hour clock operation. To change to12-hour clock operation refer
to
MANUALLY SETTING THE CLOCK section of this manual.
12-hour clock am/pm can be selected using the
AM/PM button on the remote control.
Before you start!
• If appears on the VCR display, press TIMER ON/OFF to remove the symbol.
• Check that the VCR clock is displaying the correct time.
SETTING A RECORDING
For example: Recording a programme on channel 3 from 21:05 to 22:30 on July 9th.
1. Press STOP ( ) to ensure that the VCR is
switched on.
2. Press the MENU button .
3. Press the [ / ] menu select buttons to
select
TIMER. Press SET to confirm.
4. Press SET again, the on-screen display will now
show today’s date.
If you wish to change the date use the
[ / ] or the
NUMBER BUTTONS. Enter
two digits for the day, then two for the month.
For example for July 9th, press
0 9 (9th), then 0
7 (July).
When the correct date for your recording is
shown, press the menu select button to move
to the next setting.
5. If you want to make additional recordings at
the same time each day or week, use
[ / ] to select D (daily) or W (weekly).
Then press to move to the next setting.
6. Enter the channel number using the [ / ]
or the
NUMBER BUTTONS. For example to
record a programme on channel 3, press 0 3.
Then press to move to the next setting.
MENU SCREEN
V I DEOPLUS+
TIMER
MODE
SET UP
MN :SELECT
SET :ENTER MENU:EX I T
1/2
DATE PR START STOP
21/060212:0013:00SP
9/07 -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
DATE PR START STOP
21/060212:0013:00SP
9/07D -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
MENU SELECT
BUTTONS
REMOTE CONTROL
TINS-3812UMZZ ENGLISH.book Page 15 Friday, May 5, 2000 11:43 AM
To Next Page
Loading...
