28
If problems persist contact the SHARP Helpline on tel: 0990-274277
MORE INFORMATION ABOUT YOUR VCR
ON-SCREEN DISPLAY
All the information you need on the VCR status will be summarised on the on-screen display.
If you are recording, playing back a tape or watching a broadcast on the video channel you
can call up three standard on-screen displays. The display can be selected by pressing the
MODE OSD button on the remote control, 1,2,3 or 4 times.
1. AUTO, the current mode and channel
number will be displayed for 3 seconds when an
operation or number button is pressed.
2. FULL., all the active features will also be shown
on screen.
3. COUNTER, this display will show the tape
counter and amount of tape remaining.
4. DISPLAY OFF, this will remove the display
from the screen.
NOTES:
• The default time and date will not be displayed if the clock has not been set.
• The VCR will return to display
1. each time it is switched on.
• If you are recording from this VCR to another, make sure you remove the display from
the screen otherwise it will be recorded.
1.
■ 1CH59
SP
Programme number and channel
Tape Status
Tape speed
Tape remaining
Time
Date
Tape counter
2.
■ 1CH59
SUPER P . ON
SP
22:00 REM1:05
9/07 00 0:00.00
REM 1:05
0:00.00
3.
TINS-3812UMZZ ENGLISH.book Page 28 Friday, May 5, 2000 11:43 AM
To Next Page
Loading...
