Sharp VC-MH321HM - Page 12

BASIC OPERATION
HOW TO PLAYBACK A VIDEO TAPE
SHARP SUPER PICTURE should enhance the picture quality during playback. It is
normally set to ON, To turn SHARP SUPER PICTURE on or off press SUPER P. (SET) on
the VCR front panel.
@ For double speed playback (without sound), press PLAY/X2 (> ) again.
@ To revert to normal playback, press PLAY/X2 (P ) again.
@ To stop the video tape, press STOP (@ ).
@ To eject the tape press on the VCR.
PICTURE DISTURBANCE DURING PLAYBACK
This VCR has an automatic tracking system which reduces picture disturbance when you start
to playback a video tape. When auto-tracking is in operation “ye flashes on the on-screen
display. If the picture still has disturbance you may need to manually track the video tape:
During PLAYBACK of a video tape.
@ Press CHANNEL & or © to position picture interference off the TV screen. (Manual
Tracking)
@ Press CHANNEL & and Y buttons together to start Auto Tracking.
PAUSING AND SLOW MOTION
1.Press PLAY/X2 ( P ) to start the video tape playing.
2.To pause the video tape, press PAUSE/STILL (1B).
@ To minimise jitter whilst in pause mode press CHANNEL & or V .
@ Press PLAY/X2 (P ) to resume playback.
3.To playback in slow motion (without sound) press I> SLOW on the remote control. Slow
motion speed can be adjusted using the O or © buttons next to the slow button. Picture
disturbance can be improved by using the CHANNEL or Y during stow motion
playback.
@ Press PLAY/X2 ( ) to resume playback.