12
Fig. 25
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect Reed SW. lead wires from the PCB-A
3. Remove 2 screws holding the Reed SW. from the body valve.
4. Now the Reed SW. is free.
REMOVE OF REED SWITCH
Fig. 24
Reed SW.
Screw
Body valve
Reed SW. lead wire
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Remove the push SW. ass’y in accordance with “REMOVE OF PUSH SWITCH ASS’Y”.
3. Remove the reed SW. in accordance with “REMOVE OF REED SWITCH”.
4. Detach 2 clamping springs holding the heater tank ass’y with the body valve ass’y and the water outlet.
5. Remove 2 screws holding the body valve ass’y.
6. Remove 2 screws holding the water outlet.
7. Now the body valve ass’y and the water outlet are free.
REMOVE OF BODY VALVE ASS’Y AND WATER OUTLET
Heater tank
Water outlet
Screw
Clamping spring
Body valve ass’y
Back cover
Screw
To Next Page
Loading...
