-6
Page 7
1. Connecting the projector to a computer
Setting up the Projector Network Environment
This section describes the basic procedure for using the projector via the network.
If the network is already constructed, the projector’s network settings may need to be changed. Please
consult your network administrator for assistance with these settings.
Connect a LAN cable (category 5, cross-over type) between the computer and projector.
Pages 8, 9
2. Setting an IP address for the computer
Adjust the IP settings of the computer to enable one-to-one communications with the projector.
Page 10
3. Setting up a network connection for the projector
Adjust the projector network settings to conform to your network.
LAN cable
(commercially available)
Use Internet Explorer
(version 5.0 or later)
to make various
projector settings.
Temporarily change
the computer’s IP
address.
• Microsoft
®
and Windows
®
are registered trademarks of Microsoft Corporation in the United States and/or
other countries.
• All other company or product names are trademarks or registered trademarks of their respective compa-
nies.
XG-MB70X_E_P02_19.p65 04.8.6, 4:43 PM6
To Next Page
Loading...
Need help?
General
