-9
Setting up the Projector Network Environment
1
2
After confirming or setting, proceed to “3. Setting up Network Environment for the Projec-
tor”.
5 Click “Internet Protocol (TCP/IP)”,
and click the “Properties” button.
6 Confirm or change an IP address
for the setup computer.
1 Confirm and note the current IP ad-
dress and Subnet mask.
Make sure to note the current IP ad-
dress and Subnet mask as you will be
required to reset it later.
2 The factory default setting for the pro-
jector IP address is “192.168.150.2”.
Set an IP address temporarily as fol-
lows :
IP Address : 192.168.150.3
7 After setting, click the “OK” but-
ton, and then restart the com-
puter.
XG-MB70X_E_P02_19.p65 04.8.6, 2:23 PM9
To Next Page
Loading...
