Quick Start Reference Sheet
Sharp XG-PH50X
Revision B
8/10/05 SP Controls reserves the right to modify specifications without notice at any time.
NOTE: This document is intended only as a quick reference for installation – please read the following
SP Controls Application Note for a complete description of this projector driver prior to installation.
I. Driver Features
1. Input Selection Mapping
Selection 1: RGB 1 (HD15)
Selection 2: RGB 2 (BNC)
Selection 3: VIDEO 1 (RCA)
Selection 4: VIDEO 2 (S-VID)
2. Hidden Function Mapping
Selection 1: AUTO SYNC
Selection 2: ENTER
Selection 3: ADJUST LEFT
Selection 4: ADJUST RIGHT
Off: MENU
Volume Up: ADJUST UP
Volume Down: ADJUST DOWN
3. Other Driver Features
Power Status Feedback Method RS-232 Power Polling
Control Wiring Option RS-232 and Wired Remote or IR Emitter
Note: when the Panel is wired to the projector Wired Remote port, the projector remote control will no
longer function.
II. Wiring Specifications
NOTE: For a wiring diagram, please see the SP Controls Application Note for the Sharp XG-PH50X
1. RS-232:
Wire the Panel RS-232 port to a female DB9 as follows:
RX to 2
TX to 3
GND to 5
Connect this female DB9 to the projector port labeled RS-232C.
2. Wired Remote:
Wire the Panel IR/Serial port to a female 1/8" Mini as follows:
IR/SER to Tip
GND to ring
Attach to the projector port labeled Wired Remote using a male 1/8” mini to male 1/8” mini.
III. Additional Projector Information
1. The XG-PH50X requires the correct menu settings for use with the SmartPanel:
• Configure to BAUD 9600 (default) in the second OPTIONS menu
• Configure to LAN/RS-232C ENABLED in the second OPTIONS menu
2. SmartPanel customers have reported intermittent control failures using the SmartPanel with the Sharp
XG-PH50X, though as of the writing of this Application Note SP Controls believes this issue has been
resolved. Please read Section V. Special Control Note in the Application Note for more information, or
contact SP Controls Technical Support
To Next Page
Need help?
General
