SmartPanel Projector Driver Application Note
Sharp XG-PH50X
© 2005 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
help@spcontrols.com
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
UNDO
BLACK SCREEN
LENS SELECT
AUTO SYNC
ZOOM UP
ZOOM DOWN
FOCUS UP
FOCUS DOWN
ENLARGE UP
ENLARGE DOWN
KEYSTONE
RESIZE
FREEZE
MUTE
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the SmartPanel. The Configuration Utility can
be used to customize these settings your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method RS-232 Power Polling (see note 1)
Control Wiring Option Wired Remote or IR Emitter (see note 2)
Control for the Sharp with this Driver is via RS-232 and Wired Remote. An IR Emitter can alternately be
used.
NOTE: When Wired Remote is connected to the Sharp projector, the Sharp will not respond to its remote
control.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the SmartPanel Configuration and Installation
Guide.
Lockout Timer 66 seconds (see note 3)
Inactivity Shutdown Disabled
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A
1B
3A
3B
2A
2B
4A
4B
6A
6B
5A
5B
7A
7B
SELECTION
(EXT. SWITCHER CTRL)
4321
500mA MAX. CURRENT
To Next Page
Loading...
