INSTALLATION INSTRUCTIONS CEILING BRACKET AN-PHCM20
PAGE 10
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
ATTACHMENT PLATE WITH POSITIONING ASSEMBLY:
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
A. From ceiling to bottom of projector 13 5/8”
B. Length of position adjustment knuckle assembly 3 5/8”
C. Lens offset from center of lens to center of mounting bushing 1 5/8”
D. Ceiling to center of lens 10 1/16”
E. Ceiling to top of projector 6 1/2”
F. Mounting screws M4 X 12mm long metric.
DIMENSIONS AND MEASUREMENTS OF COMPONENTS FOR
SHARP MOUNTING BRACKET AN-MBCM10
CEILING PLATE 4” WIDE X 18” LONG
DISTANCE BETWEEN SETS OF MOUNTING HOLES: 1st SET 12”, 2nd SET 14”, 3rd SET 16”
ADDITIONAL POSSIBLE COMBINATIONS OF MOUNTING HOLE DISTANCE 13” & 15”
THREAD SIZE OF SWIVEL SHAFT & CEILING PLATE BUSHING 1/2” X 20
15
”
4”
12”
14”
16”
18”
VELCRO
VELCRO
CABLE ACCESS HOLE
SECURITY ANCHOR FITTING
CENTER BUSHING 7/8” DEEP
1/2X20 THREADED HOLE
7 1/4”
6 1/4”
1 7/8”
To Next Page
Loading...
