Sharp XG-PH70X

-24
Confirming the Projector
Status (Status)
On this screen, you can confirm the projector
status. You can confirm the following items :
• MAC Address
• Power
• Condition
• Lamp Timer 1
• Lamp Timer 2
• Lamp Life 1
• Lamp Life 2
• Input
• Signal Info
• Serial Number
No
te
• If you click the “Refresh” button before the
screen is displayed completely, an error
message (“Server Busy Error”) will be dis-
played. Wait for a moment and then oper-
ate again.
• For details about each item, refer to the
projector’s operation manual.
Controlling the Projector via LAN
Controlling the Projector
(Control)
On this screen, you can perform projector con-
trol. You can control the following items :
• Power
• Input Select
• Volume
• Mute (Audio)
• Black Screen
Note
• If you click the “Refresh” button before the
screen is displayed completely, an error mes-
sage (“Server Busy Error”) will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• While the projector is in standby mode, you
can only control “Power ON”.
• For details about each item, refer to the
projector’s operation manual.