EN-6
INSTALLATION INSTRUCTIONS
ACCESSORIES
To promote trouble free use of your oven
and avoid damage.
1.
Never operate the oven when it is empty. Doing so
may damage the oven.
2.
When using a browning dish or self-heating
material, always place a heat-resistant insulator
such as a porcelain plate under it to prevent
damage to the oven floor due to heat stress. The
preheating time specified in the dishes instructions
must not be exceeded.
3. Do not use metal utensils, which reflect microwaves
and may cause electrical arcing. Do not put cans in
the oven.
4. Do not place anything on the outer cabinet during
operation
5. Do not use the oven near a steamer or a fryer.
NOTE
1. If you are unsure how to connect your oven,
please consult an authorized qualified electrician.
2. Neither the manufacuture nor the dealer can
accept any liability for damage to the oven or
personal injury resulting from failure to observe
the correct electrical connection procedure.
3. Water vapour or drops may occasionally form on
the oven walls or around the door seals and
sealing surfaces. This is a normal occurrence
and is not an indication of microwave leakage or
a malfunction.
Check to make sure the following accessories are provided:
Manuals and others
NOTE:
• Operation manual
• Menu sticker
Enter cooking times or dish names in this sticker and attach to the control panel.
• Caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS)
• When you order accessories, please mention the two items: part name and model name to your dealer or
SHARP authorized service agent.
• The model name is printed on the cover of this operation manual.
1) Remove all packing materials from the inside of the
oven cavity. Remove all the blue protective film
from the outside of the oven.
2) Check the oven carefully for any signs of damage.
3) Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked.
Do not place this oven in a position which is not
easily accessible. To position the oven too high can
be dangerous because food can not be removed
safely.
4) Ensure there is a minimum free space above the
oven of 15 cm.
15 cm
5) Securely connect the plug of the oven to a standard
earthed (grounded) household electrical outlet.
6) The unit may be secured to a countertop or stand.
There is a screw hole in the bottom of the unit. After
the oven is permanently placed, drill a hole through
the counter top for a 5 mm self-tapping screw. The
hole should be 20 mm from the left side of the outer
case cabinet and 180 mm back from the front edge
of the cavity face plate.
7) This oven is not intended to stack one on top of
another.
WARNING: Always keep the caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS) close to the oven for
your reference.
Hole
To Next Page
Loading...
