Sharp YB-S1282AE - Service Call Check; Before Operation

EN-7
SERVICE CALL CHECK
BEFORE OPERATION
Please check the following before calling for service.
1. Power Supply
Check the power plug is properly connected to a suitable wall outlet.
Check the line fuse/circuit breaker is functioning properly.
2. When the door is opened:
Does the oven lamp light?
YES _____ NO _____
3. Place one cup of 150 ml water in the oven and close the door securely.
Touch these keys.
A. Does the oven lamp come on? YES _____ NO _____
B. Does the ventilation work?
(Place your hand over the ventilation openings and check for air flow.)
YES _____ NO _____
C. After 1 minute does the signal sound?
YES _____ NO _____
D. Does the cook indicator go off?
YES _____ NO _____
E. At the end of this time, is the water warm?
YES _____ NO _____
If “NO” is the answer to any of the above questions, call your dealer or an authorized SHARP Service Agent
and report the results of your check.
The operation of the oven is controlled by pressing the appropriate pads on the control panel.
A signal should be heard each time you press the control panel.
• When you first connect the microwave oven to an
electrical socket, the digital display will show
.
• The programme or check mode is cancelled when
any keys are not pressed for more than 3 minutes.
• Key pad entries can only be made when the door is
closed.
•
will appear on the display after the time
reaches zero. It will disappear when the oven door
is opened or the STOP/CLEAR key is
pressed.
SOUND SETTING
• There is a choice of 2 different sounds or no sound
on your oven.
• To set a signal, touch the SET key
twice
within 2 seconds and then touch the SIGNAL key
continuously until you hear the tone
required.
STOPPING THE OVEN
• If you want to stop the oven during cooking, press
the STOP/CLEAR key once or open the
door (except memory cooking).
To start the oven again, close the door and press
the START key within 1 minute.
• If you open the door during memory cooking, the
programme is cancelled.
• If you want to cancel a programme during cooking,
press the STOP/CLEAR key
twice.
• If you want to clear a mistake during programming,
press the STOP/CLEAR key
once.