Before First Use
Before using your Cooking Master, please ensure you read all safety and operating instructions
thoroughly, and follow the below steps prior to use.
Remove all packaging materials (including the polystyrene under the pan) and literature from
inside gift box.
Uncoil the cord and straighten it to remove any kinks.
Wipe the exterior housing and inner surface of the Cooking Master with a damp cloth, do not
immerse it in water or other liquids, and then dry thoroughly.
Prior to first use, wash the pan in warm soapy water, and then rinse and dry the heating pot
thoroughly.
Wash the low rack, Steam rack and Frying basket in warm soapy water, then rinse and dry
thoroughly.
Select a flat, stable, dry surface to operate the Cooking Master.
NOTE: The Cooking Master may emit a slight burning smell when it is being used for the first time.
Do not be alarmed, this is normal and due to manufacturing residue.
OPERATION
Operating Instructions
1. “Start / Stop”
Connect the power plug to a suitable 220-240V outlet and switch the outlet on, you will hear a
"beep" sound and the LED will turn on and show 0:00 this shows the unit is in standby mode.
Select the temperature required (refer below temperature instructions), then press the "Power"
button to start. The Timer can be adjusted while the unit has started by pressing the “ + “ or “ –
“ button. To stop the unit and return to the standby mode please press “Power” again.
2. “Temperature”
Press the "TEMP" button once, the default temperature for this appliance is 80 degrees, time
is default at 30 minutes, the temperature indicator will show 80
o
C and the LED display starts
flashing.
To adjust the Temperature to your required level press and release the “Temp” button, each
consecutive press will increase the temperature.
Once you reach 240
o
C the following press will start again at 80
o
C
When the required Temperature is selected, press “Power” to start the appliance, once
started a different temperature cannot be selected.
To change the temperature while cooking, press the “Power” key to enter standby mode,
select the new temperature required with the “Temp” button and press the “Power” key to
start again.
3. “Timer”
Press "+" or "-" button to adjust the time to what you require. Each press of the button will
adjust the time by 1 minute, if the “+” or “-“ button is held down the time will be adjusted
by increments of 10 minutes. The maximum time setting is 9 hours 59 minutes. (You can
adjust the time after setting up the temperature or during operation as required).
To Next Page
Loading...
