• OFF - configure Shelly to turn OFF, when it has power.
• Restore last mode - configure Shelly to return to the last state it was in, when it has
power.
Firmware update - update the firmware of Shelly, when a new version is released.
Time zone and geo-location - enable or Disable the automatic detection of Time
Zone and Geo-location.
Factory reset - return Shelly to its factory default settings.
• Device Information - here you can see the:
• Device ID - unique ID of Shelly
• Device IP - the IP of Shelly in your Wi-Fi network
Edit device - From here you can edit
• Device Name
• Device Room
• Device Picture
The Embedded Web Interface
Even without the mobile app Shelly can be set and controlled through a browser and
connection of a mobile phone or tablet.
Abbreviations used:
• Shelly-ID – consists of 6 or more characters. It may include numbers and letters,
for example 35FA58.
• SSID – the name of the WiFi network, created by the device, for example
ShellyPlugS 35FA58.
• Access Point (AP) – in this mode in Shelly creates its own WiFi network.
• Client Mode (CM) – in this mode in Shelly connects to another WiFi network.
Installation/Initial inclusion
Step 1
Place Shelly into the socket and wait for the WiFi LED to flash red/blue.
⚠WARNING! If you don’t see the WiFi please follow step 1 from the device inclusion
section of the guide.
Step 2
When the LED is flashing red/blue, Shelly has created a WiFi network, with names
such as ShellyPlugS-35FA58. Connect to it.
Step 3
Type 192.168.33.1 into the address field of your browser to load the web interface of
Shelly.
General - Home Page
This is the homepage of the embedded web interface. Here you will see information
about:
• Current electrical consumption
• Current state (on/off)
• Power Button
• Connection to Cloud
• Present time
• Settings
To Next Page
Loading...
