Step 4 : Safest way to charge your battery
1
Start by plugging the charger into the battery charging port. With the battery inside the bike, place the charger on a flat, safe place and connect the charger's DC output plug (barrel connector 2)
to the charging port (1) on the side of the battery.
2
Plug the charger into an electrical outlet. Connect the charger input plug(3) (110-240 volt plug) to an electrical outlet. Charging should begin and the LED charging status light on the charger
will show red.
3
Unplug the charger from the outlet, then from the charging port. When fully charged, the charging indicator light changes from red to green, first unplug the charger from the wall outlet, then
unplug the charger output plug from the battery charging port.
NOTICE: This order helps extend the battery life and effectively reduces battery damage caused by improper charging.
To Next Page
Loading...
