Assembly Instructions
◆ Handlebar Installation ( 4mm Hex Wrench )
Step 1: Loosen the bolts on your bike stem.
Step 2 : Tighten bolts to handlebar stem, but don’t tighten completely as you may want to further adjust the angle later to align more precisely. Test the
positioning,and adjust the handlebar to your preferred angle. After determining the best position, completely tighten all the bolts on the stem.
NOTICE: In addition to angle,
the height of the handlebar can be
adjusted by adding or removing the
headset spacers if needed. For those
without experience,we recommend
having a professional make such
adjustments for safety reasons.
To Next Page
Loading...
