Shengmilo MX03 - Start-Up Procedure

35
Start-Up Procedure
After the bike has been properly assembled following the assembly video, all components are secured correctly, and you have read this entire manual,
you may turn the bike on and select a power level following the steps outlined below:
1. Test the battery lock security. Ensure the key port is aligned in the “lock” position.
2. Ensure proper handlebar and seat adjustment of the bike to the rider. For details see the
"'Adjusting the Seat Height" and "Adjusting the Seat Position and Angle" section. Note that
lowering the seat so the rider can put one or both feet flat on the ground without dismounting from
the seat may offer a safer and more comfortable introduction to operating the bike. Ensure the
handlebar faceplate bolts and seatpost quick release are fully and properly secured.
3. Turn the bike on. Insert the key and turn clockwise to the open circle icon of "open, lock"
position (1), as shown (at right). Remove the key by pulling directly backward without twisting so
the key barrel remains in the "on, locked" position.
Locate the LCD display Remote (near the left handlebar grip). Hold down the center "mode"
button for approximately 2 seconds until power is delivered to the LCD display.
Ensure the key is removed from the battery before mounting or operating the bike. Leaving the key inside of the battery key barrel
while mounting, operating the bike, pedaling, dismounting, and/or removing an unlocked battery from the frame can cause damage
to the key or battery, and/or cause injury.