Pre-Ride Safety Checklist
Notice: Before every ride, and after every 25-45 miles (40-72 km), we advise following the pre-ride safety checklist.
Ensure front and rear brakes work properly.
Check brake pads for wear and ensure they are not overworn.
Ensure brake pads are correctly positioned in relation to the rims.
Ensure brake cables are lubricated, correctly adjusted, and display no obvious wear.
Ensure brake levers are lubricated and tightly secured to the handlebar.
Test that the brake levers are firm and that the brake, motor cutoff functions, and the brake light are functioning
properly.
Ensure tires are inflated within the recommended limits posted on the tire sidewalls and hold air. Ensure tires have
good tread, have no bulges or excessive wear, and are free from any other damage. Ensure rims run true and have no
obvious wobbles, dents, or kinks.
Ensure all wheel spokes are tight and not broken.
Check axle nuts and front wheel quick release to ensure they are tight. Ensure the locking lever on the quick release
skewer is correctly tensioned, fully closed, and secured.
Ensure the handlebar and stem are correctly adjusted, tightened, and allow proper steering. Perform a handlebar twist
test (see assembly step 4) to ensure the stem clamp bolt security. Ensure the handlebar is set correctly in relation to the
fork and the direction of travel.
Ensure the chain is clean, oiled, and runs smoothly.
Extra care is required in wet, salty/otherwise corrosive, or dusty conditions.
Ensure all bearings are lubricated, run freely, and display no excess movement, grinding, or rattling. Check headset,
wheel bearings, pedal bearings, and bottom bracket bearings.
Ensure pedals are securely tightened to the cranks.
Ensure the cranks are securely tightened and are not bent.
7. Derailleur and
Mechanical Cables
Check that the derailleur is adjusted and functioning properly.
Ensure shifter and brake levers are attached to the handlebar securely. Ensure all shifter and brake cables are properly
lubricated.
To Next Page
Loading...
