Shibaura MC60RD - Pre-Delivery Checklist

31
PRE-DELIVERY CHECKLIST
PRE-DELIVERY CHECKLIST
Inspect the Front Mount Mower thoroughly after
assembly to be certain it is set up properly before
delivery to the customer.
The following checklist is a reminder of points to
inspect. Check off each item as it is found to be
satisfactory, or after proper adjustment and
lubrication is made.
o Check all bolts and other fasteners to
ensure they are correctly torqued.
o Check that all cotter pins are properly
installed
o Check and make sure the driveshaft is
installed correctly, and make sure the
lockcoller is seated on the tractor PTO
shaft
o Make sure the gearbox is properly
serviced and the seals are not leaking
o Check and MAKE SURE the blades are
correctly installed and torqued to 110-130
ft. lbs.(150-1 77 Nm).
o Make sure all Safety Shields are installed
and securely in place.
o Make sure all Safety Decals are in place
and readable (Refer to page 42 for decal
location and page 43 for identification)
and securely attached to the tractor.
o Make sure all safety shields and guards
are securely in place.
DANGER: ALWAYS USE AN
APPROVED ROLL OVER PROTECTIVE
STRUCTURE (ROPS) AND SEAT BELT FOR
SAFE OPERATION. OVERTURNING A
TRACTOR WITHOUT A ROPS CAN RESULT IN
SERIOUS INJURY OR DEATH. IF YOUR
TRACTOR IS NOT EQUIPPED WITH A ROPS
AND SEATBELT SEE YOUR SHIBAURA
DEALER.
DELIVERY CHECKLIST
o Show customer how to make adjustments
and how to check blade condition and
security.
o Explain the importance of proper
lubrication and point out the lube points on
the mower.
o Point out the Safety Features and options,
and explain the importance of safety
shielding.
o Add wheel weights, ballast in tires, and/or
rear weight as necessary to improve
tractor/mower stability.
o Make sure the tractor is equipped with a
ROPS and seat belt and explain the
importance of their use.
o Explain the importance of correct lighting
when operating at night, or close to public
roadways.
o Give the Operator’s Manual to the
customer. Ask him to read and familiarize
himself with manual information,
especially all Safety Precautions.
DAILY CHECKLIST
• Check and make sure the mower is
properly and securely attached to the
tractor.
• Make sure all safety shields and guards
are securely in place.
• Check all bolts and fasteners to be sure
they are tight and clevis and cotter pins
are secure.
• Check the condition of the mowing blades
and make sure they are correctly torqued
in place.
• Check the air pressure in the tractor and
mower tyres (see page 10 for tyre
pressures).