(Step_2) Connect the Posi-Tap terminal to the Yellow with Black stripe wire, terminal №4.
Posi-Tap connector installation guide:
1. Do not strip run wire.
2. Unscrew the big end cap counter-clockwise
3. Insert the run wire in the big end cap slot.
4. Screw the big end cap to pierce and provide signal.
Connect the Full Race male and female 3-way white connectors to the speed sensor. It
is usually located to the upper crankcase under the fuel pump and the OEM sensor connector
may be black or white depending on model.
To Next Page
Loading...