19
Appendix
Junction [A] (EW-EN100)
EW-EN100 is used instead of cycle computer.
It is attached to the brake outer casing or brake hose and located near the handle bar.
•
It is not recommended to operate the button on EW-EN100 while riding. Please select your preferred assist mode before
riding.
Name of parts
LED2
LED1
Button
Junction [A]
Button
• Press: change the assist mode each time you press it.
• Press and hold (about 2 seconds): turn the light ON/OFF
• Press and hold (about 8 seconds): change to RD protection reset mode
LED1 Indicates current assist mode.
LED2 Indicates current battery level.
LED1 indications
Status Indications
OFF Assist mode: [OFF]
Lit in light blue Assist mode: [ECO]
Lit in green Assist mode: [NORM]
Lit in yellow Assist mode: [HIGH]
Lit in blue Assist mode: [WALK]
Blinks green When the light turned on
To Next Page
Loading...