Shindaiwa EB910RT - Page 29

EB910 / RT OPERATION
X7501200801 29
© 09/22 ECHO Incorporated
2. Choke
Rotate choke (B) to COLD
START position.
3. Purge Bulb
Pump purge bulb (C) until fuel is
visible. Pump bulb an additional
4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until
engine fires, or a maximum of 5
pulls.
5. If engine fires and remains
running, pull throttle trigger or
advance throttle lever to
automatically return choke to
run position, then proceed to
engine warm up. If engine fires
and dies, proceed to step 6.
6. Choke
After engine fires (or 5 pulls),
move choke lever back to RUN
position, then pull starter handle/
rope until engine starts and runs.
Allow unit to warm up at idle for
several minutes.
Note: If engine does not start
with choke in “RUN”
position after 5 pulls,
move choke to COLD
START position, and
repeat steps 3- 6.
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, move throttle lever gradually to increase engine
RPM to desired operating speed.
C
D
B
EB910
EB910RT