12(49)
1.4 Safety Regulations
1.4.1 Safety Signs and Labels
Note!
Electrical installation should be done by qualified electrician only.
Before connecting to AC Power Source, turn power switch to OFF
position. While AC power source is connected, make sure specifications
and overload protection rating of the power switch are suitable and
reliable. When the machine is under care or maintenance, turn off both
power switch and automatic operation switch.
Danger!
High presscure!
It is attached to the control box.
Warning!
High temperature surface may burn hands!
It is attached on the cover of pipe heater.
Attention!
This mark reminds you to be more careful！
Warning!
High temperature surface may burn hands！
This label should be stick to the shell of electric heating box.
To Next Page
Loading...
Need help?
General
