Shini SIC-W Series - Temperature Controller 1(Used for 3 HP~15 HP); Temperature Setting Method

31(45)
4.4 Temperature Controller 1(
Used for
4.4.1 Temperature setting method
Picture 4-1 ：
Temperature Controller 1
Table 4-1 ：
The Instruction of Temperature Controller 1
Button
Code
Normal Operation
Press this button alone
Press it with other buttons
1
Press it for 3 secs. at least:
startup/shutdown
Press and hold
it with the
defrost button 3
to make the
forced cooling work or stop
2
-1 sec.: display/ set the
value;
- Last more then 3 secs;
Enter the parameter setting
menu (input password 22)
- Set the audible alarm to
mute (buzzer)
-
3
- Last 3 secs at least: to
make the defrosting work
or stop
Press and hold it with the
compressor button 1
together to make the forced
cooling work or
stop
Attention!
When the temperature unit changes, all parameters
Used for
3HP~15HP)
Temperature Controller 1
The Instruction of Temperature Controller 1
Startup
Press it with other buttons
it with the
to make the
forced cooling work or stop
-
Press and
hold 1 sec. to
reset current
EZY setting
Press and hold
(fan button 2
and defrost
button 3)
together to
activate the
parameter reset
program
Press and hold it with the
compressor button 1
together to make the forced
stop
Press it for 1
sec. to display
the hardware
version
When the temperature unit changes, all parameters
must be reset!