Need help?Do you have a question about the Shopsmith 10-ER and is the answer not in the manual?
General| Swing Over Bed | 10 inches |
|---|---|
| Distance Between Centers | 16.5 in |
| Motor Power | 1/2 HP |
| Spindle Thread | 1 inch x 8 TPI |
| Spindle Speed | 875 - 5200 rpm |
Details all items included in the crate with the Shopsmith power tool.
Instructions for unpacking, cleaning, and preparing the Shopsmith for initial assembly.
Procedure for mounting the headrest onto the bench base.
Guidelines for installing the motor, including power and speed requirements.
Steps for connecting the motor switch to the motor and headstock.
Instructions for aligning and tensioning motor and headstock pulleys with the V-belt.
Details the key operating unit containing spindle, bearings, quill, and pulley shaft.
Instructions for setting up and performing spindle turning operations on the lathe.
Instructions for setting up and using the Shopsmith as a circular saw.
Procedures for micro-adjusting table height and tilting for sawing operations.
Procedures for aligning the miter gauge slots, rip fence, and blade for accurate cuts.
Steps for converting the Shopsmith to a vertical drill press configuration.
Fundamental rules to prevent accidents when operating machinery.
Specific safety measures for the motor and avoiding loose clothing.
Description and specifications of the 4-inch ball bearing jointer attachment.
Description and specifications of the versatile jigsaw attachment.
Emphasis on using tools with care and upgrading safety features.
To Next Page