TowerMax Canopy Cover Attachment
Step 1. Place the cover on the center rib of the canopy frame. Starting at one end and unrolling the
cover down the length of the frame. Make sure the end door is in the proper location for the frame.
Unfold down the side and adjust the cover to fit evenly around the frame.
Step 2. On the inside of the cover, you'll find slits in the webbing to wrap a bungee around. Slip the
bungee into a slit in the webbing and loop the bungee around itself, then pull tight to fasten it to the
canopy cover.
To avoid personal injury, do not let go of bungee cords when under
tension. Stretching and removing bungee cords requires strength and proper balance.
Always wear safety glasses and the proper protective clothing.
A canopy cover is a hazard if exposed to high wind. Do not attach canopy to canopy
frame if wind affects your ability to safely fasten.
To Next Page
Loading...