Step 3. Starting on the door
side, put one bungee in each
top corner of the door flap
webbing. Pull the bungee
around to the next vertical tube
of the door weldment. Work
your way down to the bottom
corners, placing one bungee
about every 12-18".
Step 4. Place one bungee along
every vertical tube of the door
weldment. Hook the bungee end
into the pre-drilled hole in the
tubes.
Step 5. Starting in the upper corner of
the door, wrap a bungee around to the
inside of the frame. Work your way
down, keeping the same spacing of
12-18". If there are wrinkles in the
cover, pull cover to adjust and work
them out. The webbing should be just
at the bottom of the frame.
Step 6. Place a bungee next to
every upright tube down the sides
and full end of the canopy. Hook the
end of the bungee to the attachment
angle as shown.
To Next Page
Loading...