Thanks for choosing SHOWVEN uFlamer Max, we wish it will bring you lots of exciting moments.
Please read the following user’s manual and related product installation guide carefully before
operating this device.
Δ Safety Instructions
1. Safety icons explanation
Safety instructions warn of hazards when handling equipment and provide information on
how to avoid those hazards. They are classified according to the severity of the hazard and are
divided into the following groups. Please do follow all safety instructions in this document!
DANGER: Indicates a hazardous situation that, if not avoided, will result in death or
serious injury. (This signal word is limited to the most extreme situations)
WARNING: Indicates a hazardous situation that, if not avoided, could result in serious
injury
CAUTION: Indicates a hazardous situation that, if not avoided, could result in minor or
moderate injury.
NOTICE: Provide additional or supplementary information.
2. General Safety Instructions
\ Unauthorized repair are prohibited, it may cause serious incident.
\ Make sure power supply in consistent with the rated voltage of the equipment, and the
socket must well grounded. Unplug and turn off the machine when not use.
\ Please connect DMX cable before power on uFlamer Max, and ensure that the
communication command is disarmed, and the safety switch of device is under test mode.
\ After turning on the device, no person allows to stay in the danger area. Ensure all persons
that are part of the show be informed about the safety distance, risks and functions of the
device.
\ Always have a CO
2
fire extinguisher and an extinguishing blanket in case of needed.
\ If there be any doubt as to the safety operation of the device in any circumstances, the
device should be taken out of service immediately. Be sure the device is in good operating
condition before use. If fail to fire correctly, immediately shut down and check it accordingly.
Any questions please always contact SHOWVEN (info@showven.cn) for help.
\ Be sure to use high quality fuels, otherwise, it is easily leads to failure or danger. Please
keep fuels away from heat source, sparks, fire or other possibility of ignition. Do not smoke!
\ The operator responsible for the control of flame system must always have a clear view of
the device, so that he/she can stop the show immediately when there is danger. The main
AC power switch should near operator. So that operator can turn off the power of all
devices in case of abnormal.
\ The device shall not be altered and applied to other use purpose.
3. Disclaimers:
SHOWVEN technologies Co., Ltd excludes liability for unsafe situations, accidents and
damages resulting from:
1. Ignoring warnings or regulations as shown on product manual or this manual.
2. Use for other applications or circumstances other than those indicated herein.
3. Changes to the device, including use of non-original spare parts, lack of maintenance etc.
4. Dismantling device without authorization from SHOWVEN.
5. Use this machine by unqualified or untrained personnel.
6. Improper use of machine
To Next Page
Loading...
