0~9: NO output
10~255: Hopper 1 output increase
0~9: NO output
10~255: Hopper 2 output increase
0~ 49 and 201~255: Device disabled
50~200: Device enabled
Δ Operation
1. Safety instructions
DANGER: Make sure that confetti cannot come into contact with high-voltage lines/power pylons,
as this can result in electrocution.
WARNING: All operations must be performed by professionals, and non-professionals are prohibited
from operating.
WARNING: Use of a damaged or improperly installed machine could result in death, serious injury, or
property damage. Always inspect the machine thoroughly before operating it.
WARNING: Do not use the uFetti Blower if alterations have been made other than by or on behalf of
SHOWVEN.
WARNING: Make sure there are no objects that can be damaged by the machine within the output
distance. And no people or animals are allowed to stay in the direct output.
WARNING: Make sure power supply in consistent with the rated voltage of the equipment, and the
socket must well grounded. Do not connect more units to a single electrical circuit than
the installed fuse is able to handle. Recommended to connect only a single unit of device
to a power supply cable.
WARNING: Make sure there are no objects near the air inlet port that can block the air to be sucked
in.
WARNING: The red cone area shown in below picture is the safe isolation range of this product, and
unauthorized persons or objects are strictly prohibited from entering. A=10m, B=40 .
2. Install uFetti Blower
2.1 Bring the machine to desired location.
To Next Page
Loading...