Why does my SHUR-DRI SDVS3-01 Water Pump start and stop too often?
If your SHUR-DRI Water Pump is starting and stopping too frequently, it could be due to backflow of water from the piping. In this case, install or replace the check-valve. Another possible cause is a faulty float switch, which would need to be replaced.
How to fix a SHUR-DRI SDVS3-01 that won’t shut off?
If your SHUR-DRI Water Pump won’t shut off, a defective float switch is a likely cause, so you should replace it. Another reason could be a restricted discharge due to an obstacle in the piping; remove the pump and clean both the pump and the piping. Also, check for a float obstruction and remove it.
What to do if my SHUR-DRI SDVS3-01 Water Pump won’t start or run?
If your SHUR-DRI Water Pump isn’t starting, there could be several reasons. First, check the fuse or breaker and replace it with the correct size or reset it if needed. Also, check the line voltage; if it's below the recommended minimum, inspect the wiring size from the main switch. Other potential causes include a defective motor or float switch, in which case you should replace the pump or float switch, respectively. Finally, ensure that the float isn't obstructed and remove any obstructions.
What to do if my SHUR-DRI SDVS3-01 Water Pump operates but delivers little or no water?
If your SHUR-DRI Water Pump runs but isn't delivering enough water, start by checking the line voltage. If it's below the recommended minimum, examine the wiring size from the main switch on your property. Also, the impeller might be worn or plugged, requiring you to replace the pump. Lastly, the anti-airlock vent hole could be plugged; try cleaning it with a hat pin or pipe cleaner.
General| Model | SDVS3-01 |
|---|---|
| Horsepower | 1/3 HP |
| Voltage | 115V |
| Maximum Head | 25 ft |
| Cord Length | 10 ft |
To Next Page
