channels to multiple receiving devices across the network.
Shure Device Applications
This device can connect with up to two Dante devices.
The Shure MXA310, ANI22, ANIUSB-MATRIX and ANI4IN support multicast transmission.
This means that flows can transmit to multiple devices -- as many as the network can
support. If using unicast flows, each of these devices can connect with up to two Dante
receiver devices.
The Shure ANI4OUT connects with up to two Dante transmitter devices.
Pushing Device Names to the Dante Network
To send a device name to appear in Dante Controller, go to Settings>General and enter a
Device Name. Select Push to Dante to send the name to appear on the network.
Note: names appear in Dante Controller with "-d" attached.
ANIUSB Command Strings
The device is connected via Ethernet to a control system, such as AMX, Crestron or
Extron.
Connection: Ethernet (TCP/IP; select “Client” in the AMX/Crestron program)
Port: 2202
Conventions
The device has 4 types of strings:
GET Finds the status of a parameter. After the AMX/Crestron sends a
GET command, the ANIUSB responds with a REPORT string
SET Changes the status of a parameter. After the AMX/Crestron sends
a SET command, the ANIUSB will respond with a REPORT string to
indicate the new value of the parameter.
REP When the ANIUSB receives a GET or SET command, it will reply
with a REPORT command to indicate the status of the parameter.
REPORT is also sent by the ANIUSB when a parameter is changed
on the ANIUSB or through the GUI.
SAMPLE Used for metering audio levels.
All messages sent and received are ASCII. Note that the level indicators and gain
indicators are also in ASCII
Most parameters will send a REPORT command when they change. Thus, it is not
necessary to constantly query parameters. The ANIUSB will send a REPORT command
when any of these parameters change.
To Next Page
Loading...
