Shure PSM 200 User Manual (English)

Other manuals for Shure PSM 200

Questions and Answers:

A
Andrea BlevinsJul 26, 2025
How to troubleshoot no sound at the Shure Microphone system receiver?
- J
  John Lin DDSJul 26, 2025
  If you're not getting any sound at the receiver of your Shure Microphone system, first, check the power cord on the TransMixer and ensure it's powered on. Next, verify that both the TransMixer and the P2R Receiver are set to the same frequency channel. Also, ensure that your earphones are properly plugged into the receiver and the volume is turned up. Confirm that the receiver is on and the battery is in good condition. Finally, check the incoming audio connections on the TransMixer.
N
Nicholas HoustonAug 2, 2025
What to do if Shure Microphone system receiver sounds fuzzy or distorted?
- D
  Daniel GambleAug 2, 2025
  If your Shure Microphone system receiver sounds fuzzy or distorted, ensure that no other TransMixers or wireless transmitters are operating on your frequency. Also, make sure the TransMixer input level is lighting yellow LEDs for optimum performance. Finally, ensure you are using a fresh battery in the P2R.
T
Thomas GarrettAug 10, 2025
Why is the audio output low on my Shure Microphone system receiver?
- L
  Laura AndrewsAug 10, 2025
  If you are experiencing low audio output at the receiver for your Shure Microphone system, ensure the TransMixer input level is lighting yellow LEDs for optimum performance. Additionally, make sure the P2R Receiver’s volume knob is turned up.
T
Teresa HollandAug 18, 2025
How to improve the receiver range of a Shure Microphone system?
- E
  Edward RyanAug 18, 2025
  If you're experiencing a low receiver range with your Shure Microphone system, try to maintain line-of-sight between the TransMixer and Receiver antennas. You might also try another frequency in case interference is limiting the range. Additionally, check for television channel interference.

Shure PSM 200 Specifications

General

Transmitter Output Power	10 mW
Modulation	FM
System Type	Personal Monitor System
Audio Input Connector (Transmitter)	XLR, 1/4"
Audio Output Connector (Receiver)	1/8" (3.5 mm) stereo headphone jack
Power Supply (Transmitter)	12 VDC
Audio Input Connector	XLR, 1/4"
Operating Range	Up to 300 ft (90 m) typical
Dimensions	Receiver: 4.5" H x 2.5" W x 1" D (114 mm x 64 mm x 25 mm)