ENGLISH
10
SYSTEM APPLICATIONS
This section presents three typical applications for the PSM200. For more ideas, visit Shure’s website at www.shure.com.
APPLICATION ONE: Wireless Set-Up for a Vocalist
This is the basic wireless configuration of the PSM200 system for a single user, either instrumental or vocal:
1. Connect the vocal mic to INPUT 1 of the P2T TransMixer.
2. Connect SPLIT OUT 1 from the P2T to the Mixing Console.
3. Connect the instrumental mix line out to INPUT 2 of the P2T.
4. Set the P2T and P2R to the same frequency channel.
5. Insert the E2 earphones into your ears and adjust the mix of INPUT 1 and INPUT 2 on the TransMixer.
Wireless
Transmission
Vocal Mic Signal
SPLIT OUT
from TransMixer
Band Mix
Vocal Mic
Mixing Console
APPLICATION TWO: Combination Wired and Wireless Set-Up for a Drummer
The following application uses the P2R as a combination wired/wireless Receiver. The MIX IN jack of the P2R is connected
to a click track for the drummer:
1. Connect the drum mix out of the Mixing Console to INPUT 1 of the P2T TransMixer.
2. Connect the band mix out of the Mixing Console to INPUT 2 of the P2T.
3. Set the P2T and the P2R to the same frequency channel.
4. Insert the E2 earphones into your ears and adjust the mix of INPUT 1 and INPUT 2 on the TransMixer.
5. Set the P2R Receiver to a comfortable level.
6. Set the GAIN switch on the P2R to LOW.
7. Connect the Click Output to the MIX IN
1
/
4
-inch jack of the P2R and adjust your levels.
Mixing Console
Click
Track
Drum Mix
Band Mix
To Next Page
Loading...
