ENGLISH
4
P2R Receiver Quick Set-Up Guide:
When Used as a Wired Stand-Alone Personal Monitor
1. Insert a 9 Volt battery into the P2R Receiver,
observing proper polarity.
6. Attach the P2R onto your belt, waistband, or another
location and slide the cable into the cable management
groove on the back side of the unit.
Mixing Console
3. Turn the P2R volume knob on (past the click).
Keep the volume at a low setting.
2. Connect an audio source to the
1
/
4
-inch MIX IN jack
on the side of the P2R.
4. Set the CHANNEL to “A” with the SELECT Button.
See the Wired Mode section on page 10 for details.
5. Set the GAIN switch to LOW initially and set
your source volume to a moderate level.
7. Plug Earphones into the earphone jack on the P2R.
Insert the Earphones into your ears.
8. Slowly adjust the volume to a comfortable level. Set
the GAIN switch to HIGH if the signal level is too low.
Mixing Console
To Next Page
Loading...
