ENGLISH
12
TROUBLESHOOTING
PROBLEM SOLUTION
No sound at the receiver Check the power cord on the TransMixer and make sure it is
powered on.
Make sure both the TransMixer and the P2R Receiver are set to
the same frequency channel.
Make sure the earphones are plugged in to the receiver and the
volume is up.
Make sure the Receiver is on and the battery is good.
Check the incoming audio connections on the TransMixer.
Low receiver range Try to maintain line-of-sight between the TransMixer and Receiver
antennas.
Try another frequency in case interference is limiting the range.
Check for television channel interference. More information is
available at www.shure.com.
Receiver sounds fuzzy or distorted Make sure no other TransMixers or wireless transmitters are oper-
ating on your frequency.
Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
Make sure you are using a fresh battery in the P2R.
Low audio output at the receiver Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
Make sure the P2R Receiver’s volume knob is up.
ACCESSORIES
Furnished Accessories
P2T TransMixer
AC Adaptor PS20, PS20E, PS20UK. . . . . . . . . . . . . . . .
Rack Mount Kit 53B8484. . . . . . . . . . . . . . . . . . . . . . . . . .
P2R Receiver
1/4–inch mono 20 foot cable 90B4677. . . . . . . . . . . . . .
Optional Equipment
AuxPander:
The Shure AuxPander auxiliary expander extends the capabili-
ties of a standard mixing console by providing eight additional
auxiliary sends. It is designed ideally for use with multiple per-
sonal monitoring systems.
P4M:
The P4M is a highly versatile four–channel, two–bus stereo
mic/line mixer designed to optimize personal (in–ear) monitor
systems in live performance applications.
AP200:
You can use the AP200 adaptor to connect a lavalier micro-
phone to the MIX IN jack on the P2R Receiver. The AP200
includes a Shure WL93 omnidirectional microphone that al-
lows you to combine your wireless mix with ambient sound
from your surroundings.
SPECIFICATIONS
PSM200 System
RF Carrier Frequency Range
518–865 MHz (country dependent)
Operating Range
100 m (300 ft.) under optimal conditions
Audio Frequency Response
30 Hz to 12 kHz (+/–3 dB); earphone dependent
Total Harmonic Distortion (1 KHz)
<1% typical (Ref. ±35 kHz deviation)
Modulation
FM ±35 kHz Deviation (Nominal)
Signal-to-Noise Ratio
80 dB typical (A-weighted)
Operating Temperature
–7° C to +49° C
(+20° F to +120° F)
To Next Page
Loading...
