Shure Incorporated
8/15
VLIMIT (Maximum Volume)
Set a value (-3 to -21 dB) to attenuate the highest possible volume level. Turning the volume
knob through its entire range of motion still affects volume; the limit simply narrows the range
of dB adjustment.
Note: The VLIMIT does not compress the audio.
BAL MX / BAL ST (Balance)
The behavior of the balance control depends on which mode the bodypack is set to:
STEREO: Adjusts the left/right balance
MIXMODE: Adjusts the blend between channel one and channel two
INPUT
Line (+4 dBu): Use with mixers and other professional devices that send a line-level
signalAUX (10 dBV): Use with consumer electronic devices, such as MP3 players or com
puters.
Utilities
CONTRAST Customize the display screen contrast by selecting a setting between low and high
LOCK PANEL
Locks all controls except the volume knob to prevent accidental changes to settings
Lock: Select UTILITIES > LOCK PANEL
Unlock: Press the exit button and select OFF when the lock setting screen appears. Press
enter to confirm.
BATTERY
Displays remaining battery runtime (hours:minutes), temperature, status, cycle count, health,
and voltage
Note: Applies to SB900A battery only
RESTORE Restores bodypack to factory default settings
AUTO OFF
Automatically turns off the bodypack after a selectable amount of time (5, 30, or 60 min.)
while it is in power-save mode or when connected to a charger with the power on. To restore
power to the bodypack, the power switch must be turned off and then on again.
Note: SB900A batteries charge fastest when the bodypack is off
MixMode and Stereo Monitoring
The bodypack can operate in either of the following listening modes:
Stereo (default)
To operate in stereo mode, enter the menu and select AUDIO > MODE > STEREO .
In stereo mode, audio from channel 1 is heard on the left earphone, while audio from channel 2 is heard on the right earphone.
Listening in stereo increases clarity and separation between the sources on each channel.
To Next Page
