Shure RMCE-BT2 - Using the Remote Control; Center Button Functions; Volume and Track Controls; Charging the Earphones

Usihg the Remote
The Center Button
Power on
Power off
Pair Bluetooth
Play/Pause
Answer/End a call
Decline a call
Activate voice assistant
Factory Reset
Press and hold
Press and hold, 5
seconds
Turn off the earphones.
Press and hold, 7
seconds
Click once
Click once
Press and hold, 3
seconds
Phone on, press and
hold, 3 seconds
Turn off the earphones
and plug into a charger.
Press and hold, 15
seconds. Hold past
pairing mode until
earphones turn off
again.
Up and Down Buttons
Volume Up/Down
Next track
Previous track
Check battery status
Click+ or -
Press and hold +, 3
seconds
Press and hold -, 3
seconds
Press and hold + and -
together, 3 seconds
Your phone may not be compatible with some functions.
Visit http://www.shure.com/earphones for more information.
Charging the Earphones
Red LED indicates low battery.
1. Connect the earphones to a charging
device using the supplied USB cable.
2. The LED is red while charging.
3. When fully charged, the LED turns off.
Warning: Before charging, make sure the product is at room
temperature, between 10 to 45°C (50 to 113°F).
Note: Use this product only with an agency approved power
supply which meets local regulatory requirements (e.g., UL,
CSA, VOE, CCC, INMETRO).