How to troubleshoot no sound on Shure Microphone system?
If there is no sound from your Shure Microphone system, ensure that both the transmitter and receiver are getting enough power. The receiver needs at least 90 Vac. Also, check the battery indicator on the transmitter and replace the battery if needed. Verify that all cables and connectors are in good working order.
Why does my Shure Microphone system have a lack of range, unwanted noise bursts, or drop outs?
If your Shure Microphone system transmitter is too far (more than 6 to 60 m or 20 to 200 ft) from the receiver antenna, try reducing interference or increasing the transmitter RF power level. You might also use an active directional antenna, antenna distribution system, or other antenna accessory to increase RF range.
How to fix excessive hum or buzzing in Shure Microphone system?
To resolve excessive hum or buzzing in your Shure Microphone system, if you are using the XLR connector, set the GND/LIFT switch on the receiver to LIFT. This lifts the ground on pin 1 of the XLR output on the receiver, which can sometimes remove the hum or buzz.
What to do if I cannot turn transmitter off or change frequency settings on Shure Microphone system?
If you cannot turn off the transmitter, change frequency settings, or program the receiver on your Shure Microphone system, it might be locked. Look for a lock symbol on the LCD of the transmitter and use the key combinations to turn it off.
Why does my Shure Microphone system have faint sound or distortion?
If you are experiencing faint sound or distortion with your Shure Microphone system, adjust the transmitter gain and sensitivity settings or the receiver output level, or toggle the mic/line switch on the back of the receiver.
General| THD | <0.5% |
|---|---|
| Frequency Range | 470-952 MHz (region-specific) |
| Modulation | FM |
| Power Supply | 2 AA batteries |
| Housing | Machined aluminum |
To Next Page
