Need help?Do you have a question about the Shure ULXD4Q and is the answer not in the manual?
General| Quantity | 1 |
|---|---|
| Impedance | 50 Ω |
| Antenna type | Removable |
| Display type | LCD |
| Ethernet LAN | Yes |
| Mounting type | Rack mount |
| Product color | Black |
| Backlight color | White |
| Housing material | Metal |
| Compatible products | AMX and Crestron control systems |
| Operating frequency type | Ultra High Frequency (UHF) |
| Radio Frequency (RF) range | 606 - 670 MHz |
| Microphone frequency response | 20 - 20000 Hz |
| XLR out | 4 |
| RJ-45 ports quantity | 2 |
| Power supply type | Battery |
Weight and Dimensions| Depth | 274 mm |
|---|---|
| Width | 482 mm |
| Height | 44 mm |
| Weight | 3450 g |
Covers tuning range, active transmitters, High Density mode, and RF signal stability.
Description of the receiver's front panel interface, buttons, and displays.
Explanation of transmitter parts, display, buttons, and battery compartment.
Guidance on setting gain, reading audio meters, and output levels.
Step-by-step guide to tuning receivers and transmitters to optimal frequencies.
Explanation and setup for High Density and Frequency Diversity modes.
Instructions for updating receiver and transmitter firmware.
Steps for automatic and manual IP address setup for network communication.
Explanation of Switched, Redundant Audio, and Split Dante network modes.
Procedure to select and set the Dante network mode.
Details on using Redundant mode for audio backup and its network characteristics.
Details on using Split mode for isolating control and audio signals.
Steps to set Shure Control and Dante Device IDs for network organization.
Troubleshooting table for common problems like no sound, distortion, or range issues.
To Next Page
