Need help?Do you have a question about the Shure ULXD4D and is the answer not in the manual?
General| Dynamic Range | >120 dB, A-weighted |
|---|---|
| RF Sensitivity | -98 dBm at 10-5 BER |
| Tuning Steps | 25 kHz |
| Compatible Transmitters | ULXD1, ULXD2 |
| THD | <0.1% |
| Latency | 2.9 ms |
| Frequency Range | 470–937.5 MHz (varies by region) |
| Audio Frequency Response | 20 Hz – 20 kHz |
| Operating Range | Up to 100 meters (300 feet) under typical conditions |
| Encryption | AES 256-bit encryption |
| Network Capability | Ethernet |
| Power Requirements | 100 to 240 V AC, 50/60 Hz |
| Image Rejection | >80 dB |
| Spurious Rejection | >80 dB |
| Audio Output Level | XLR: +18 dBV, 1/4": +12 dBV |
| Audio Output Impedance | 50 ohms |
| Operating Temperature Range | -18°C to +57°C |
| Connectors | XLR, 1/4", Ethernet |
Highlights audio quality, RF performance, scalability, and power management of the ULX-D wireless system.
Explains RF MUTE, transmitter input clip warnings, and MIC.OFFSET settings.
Covers AA battery installation and provides a runtime chart based on RF power.
Explains SB900 battery information display and installation into the transmitter.
Explains how to adjust system gain on the receiver for optimal audio levels.
Guides on tuning a receiver and transmitter to the best open channel.
Details how to manually adjust group, channel, or frequency settings on the receiver.
Provides instructions for setting up networked and non-networked receiver systems.
Guides on enabling and configuring High Density mode for increased channel capacity.
Describes Frequency Diversity feature for safeguarding against RF interference.
Provides steps for updating receiver firmware using Shure Wireless Workbench software.
Details the process of transferring firmware updates to transmitters via the receiver.
Details how to lock receiver functions like Menu, Gain, Power, and Scan/Sync.
Explains how to lock transmitter functions such as Menu and Power.
Describes how to enable AES-256 encryption for secure wireless transmission.
Covers Automatic and Manual IP addressing for network setup.
Details how to select and set Dante networking modes (Switched, Redundant, Split).
Explains how to set the Device ID for Shure Control within WWB6 or receiver.
Details how to set the Dante Device ID from the receiver menu or Dante controller.
Guides on forming audio routes (subscriptions) between transmitters and receivers in Dante Controller.
Provides common network issues and solutions, including connectivity checks.
Explains how to manage and monitor receiver settings via Wireless Workbench software.
Covers no sound, distortion, range, noise, and dropouts.
Covers encryption mismatches, antenna faults, interference, and range.
Lists frequency bands and corresponding transmitter output power levels by region.
Provides crucial safety warnings regarding battery handling and replacement.
Advises contacting national authorities for authorized frequencies and RF power levels.
To Next Page
