Need help?Do you have a question about the Shure ULXS4 and is the answer not in the manual?
General| Receiver Type | Diversity |
|---|---|
| Frequency Stability | ±0.005% |
| Frequency Range | 470–865 MHz (available frequencies depend on applicable regulations in country of use) |
| Image Rejection | >70 dB typical |
| Output Impedance | 200 ohms |
| Modulation | FM |
| RF Carrier Frequencies | 470-952 MHz (region dependent) |
| Number of Frequencies | 1440 frequencies across 24 MHz bandwidth |
| Dynamic Range | >100 dB |
| Signal-to-Noise Ratio | >100 dB A-weighted |
| Operating Range | Up to 100 meters (300 feet) under optimal conditions |
| THD | <0.5% typical |
Lists typical battery life for recommended 9V alkaline and lithium batteries.
How to use group scan to find optimal open channels.
Details FCC and IC certifications for ULX systems.
Guidance on licensing requirements for wireless equipment.
FCC compliance details and steps to correct interference.
Technical details for ULX transmitters.
Technical details for ULXS4 and ULXP4 receivers.
Details on analog audio output configurations and levels.
To Next Page
