Page 4
probe perpendicular to the bottom; the probe is non directional.
Avoid mounting the probe in an area that will submerge the
inside portion of the probe in warm bilge water, or Ice water from
fish boxes. Also, avoid mounting the probe near the engine
exhaust, as this will adversely affect the overall accuracy of the
sea water temperature indication
The Si-Tex SST110 provides accurate digital instrumentation
for sea water temperature with a resolution of 0.01 degree
Fahrenheit or Celsius.
For maximum accuracy, the displayed temperature may be
calibrated using the front panel keys to compensate for slight
differences in temperature transducers.
You can set high and low temperature alarms and a temperature
trend arrow lets you know with a glance if the sea temperature is
getting warmer, cooler or constant.
Five levels of backlighting can be selected and remotely switched
ON/OFF. All setup and calibration constants are saved to a
nonvolatile memory. The SST110 outputs standard NMEA
0183 data of water temperature in Degrees F and degrees C and
works on both 12 and 24 VDC systems.
The SST110 with its large display digits draws only .035 amps
and only .055 amps with full backlighting. Both transom mount
and thru-hull mount temperature transducers are available sepa-
rately.
The SST110 works with 30Kohm temperature senders and is
fully compatible with the popular Dytek temperature probe.
To Next Page
Loading...